Best sellers
Showing 505-540 of 950 item(s)
12 24 36
FAULTS SIMULATION APPLICATION IN ELECTRICAL MOTORS - AEL-ESAM
  • AEL-ESAM
Available
4.3.2.1.- AC ELECTRICAL MOTORS AND GENERATORS
AEL-ESAM
Faults Simulation Application in Electrical Motors
The Faults Simulation Application in Electrical Motors, "AEL-ESAM", has been designed by EDIBON to simulate non-destructive faults in three-phase motors and application of diagnostic and localization techniques.This application allows simulating...
View Unit
FILLING PROCESS OF TANKS - N-EM-PLLT
  • N-EM-PLLT
Available
6.2.2.2.- FLOW AND LEVEL CONTROL
N-EM-PLLT
Filling Process of Tanks
The "N-EM" are a series of emulators that provide the students the required hardware to emulate the most common automatic systems.The "N-EM" modules are designed to work with the "AE-PLC" units to obtain the fundamental knowledge of PLC...
View Unit
FILM AND DROPWISE CONDENSATION UNIT - TCPGB
  • TCPGB
Available
9.7.- HEAT EXCHANGERS
TCPGB
Film and Dropwise Condensation Unit
The Film and Dropwise Condensation Unit, "TCPGB", designed by EDIBON, students use and to provide visual results and quantitative results related to heat transfer during condensation.Self-contained unit, which has its own steam generator and air...
View Unit
FILTERS MODULE - N-M8
  • N-M8
Available
14.2.1.2.- ANALOG ELECTRONICS
N-M8
Filters Module
An electronic filter is an element that allows electrical signals to pass through it, at a specific frequency or frequency ranges while preventing the passage of others, being able to modify both, their amplitude and phase. It is a device that...
View Unit
FINAL USER SMART GRID - NET METERING APPLICATION - AEL-FUSG-N
Available
5.1.2.- SMART GRIDS AND POWER SYSTEMS (END USER)
AEL-FUSG-N
Final User Smart Grid - Net Metering Application
Accessory of AEL-FUSG
Through this application, the user can simulate the sale or consumption of generated energy. Thus, the user can perform different simulations such as electricity sale to the grid, Net Metering, and measuring the input and output of power flows...
View Unit
FINAL USER SMART GRID - SMART ENERGY APPLICATION - AEL-FUSG-E
Available
5.1.2.- SMART GRIDS AND POWER SYSTEMS (END USER)
AEL-FUSG-E
Final User Smart Grid - Smart Energy Application
Accessory of AEL-FUSG
Final User Smart Grid - Smart Energy Application, "AEL-FUSG-E", designed by EDIBON, is an application that reflects the behavior of real Home Energy Management Systems.The purpose of the "AEL-FUSG-E" application is to help the user understand how...
View Unit
FINAL USER SMART GRID - SMART METER APPLICATION - AEL-FUSG-M
Available
5.1.2.- SMART GRIDS AND POWER SYSTEMS (END USER)
AEL-FUSG-M
Final User Smart Grid - Smart Meter Application
Accessory of AEL-FUSG
The Smart Grid (End User) - Smart Meter Application, "AEL-FUSG-M", designed by EDIBON, offers a real smart grid system where users can manage a real smart meter.This application reflects the real operation of modern Smart Grids. The objective of...
View Unit
FINAL USER SMART GRID SYSTEM - AEL-FUSG
  • AEL-FUSG
Available
5.1.2.- SMART GRIDS AND POWER SYSTEMS (END USER)
AEL-FUSG
Final User Smart Grid System
The "AEL-FUSG" system consists of three main applications: AEL-FUSG-M. Smart Grid (End User) – Smart Meter Application.. To understand how current electric utilities operate in today’s electrical networks, EDIBON has designed the Smart Grid...
View Unit
FIRE ALARM ADVANCED APPLICATION - AEL-AD3A
  • AEL-AD3A
Available
4.2.1.- CONVENTIONAL APPLICATIONS
AEL-AD3A
Fire Alarm Advanced Application
The Fire Alarm Advanced Application, "AEL–AD3A", has been designed by EDIBON to study different types of fire alarms. This complete application includes several types of sensors and alarms. The sensors included are a smoke detector, an ionized air...
View Unit
FIXED AND FLUIDIZED BED UNIT - LFF
  • LFF
Available
11.1.1.- FLUIDIZATION
LFF
Fixed and Fluidized Bed Unit
The Fixed and Fluidized Bed Unit, "LFF", allows a full study about everything concerning the flow of a fluid through a particles bed, both fixed and fluidized.The unit is composed of two transparent removable columns for the simultaneous study of...
View Unit
FIXED-BED CATALYTIC REACTORS FOR SUCROSE HYDROLYSIS - QRCB
  • QRCB
Available
11.2.- CHEMICAL REACTORS
QRCB
Fixed-Bed Catalytic Reactors for Sucrose Hydrolysis
Sucrose hydrolysis is a reversible reaction widely used at the industrial level to produce glucose and fructose. This process benefits greatly from catalysis, both chemical and enzymatic, and is a representative example of using fixed-bed reactors...
View Unit
FLOCCULATION TEST UNIT - PEF
  • PEF
Available
13.3.- WASTEWATER TREATMENT
PEF
Flocculation Test Unit
The Flocculation Test Unit, "PEF", designed by EDIBON, shows the removal of dissolved substances by coagulation and flocculation.It has six beakers where water to be tested is poured. Each one has one adjustable speed paddle stirrer.The unit is...
View Unit
FLOW CHANNEL, LENGTH: 1 M - FME25
  • FME25
Available
8.1.5.- FLOW VISUALIZATION
FME25
Flow channel, length: 1 m
The Flow Channel, length: 1 m unit, "FME25", designed by EDIBON, allows to studying the behaviour of water flowing through a one-meter channel.It basically consists of a channel of rectangular cross section with transparent walls, through which...
View Unit
FLOW CHANNELS - CFG
  • CFG
Available
8.5.- HYDRAULIC CHANNELS
CFG
Flow Channels
Channel made up of group of modular parts of 2.5 m long. Each rectangular piece of different sections with transparent walls of 10 mm thick is made in such a way that guarantees a uniform section along the entire channel. All the sections are made...
View Unit
FLOW CHANNELS (SECTION: 80X300 MM) - CF
  • CF
Available
8.5.- HYDRAULIC CHANNELS
CF
Flow Channels (section: 80X300 mm)
Channel, through which water flows, of rectangular section with transparent walls that enable to observe all the experiments. Water is taken from the storage tank by means of a hydraulic pump and, by the pipe, it is driven to the inlet tank, where...
View Unit
FLOW METER DEMONSTRATION - FME18
  • FME18
Available
8.1.2.- MEASUREMENT
FME18
Flow Meter Demonstration
The Flow Meter Demonstration unit, "FME18", designed by EDIBON, consists of a Venturi meter, a flowmeter and an orifice plate, installed in a series configuration to permit a direct comparison.Several pressure taps are connected to a panel of...
View Unit
FLOW METERS DEMONSTRATION - FMDU
  • FMDU
Available
8.2.- MEASUREMENT
FMDU
Flow Meters Demonstration
Flow Meters Demonstration, "FMDU", designed by EDIBON, demonstrates the important characteristics of fifteen types of flow meters used in the measurement of water flow through pipes or open channels.The main element is the FMDU Base Unit,...
View Unit
FLOW OVER WEIRS - FME02
  • FME02
Available
8.1.2.- MEASUREMENT
FME02
Flow over Weirs
The Flow over Weirs unit, "FME02", designed by EDIBON, has many elements that are used in combination with the Hydraulics Bench (FME00):A special mouthpiece is coupled to the outlet mouthpiece for water in the Hydraulics Bench (FME00).Two soothing...
View Unit
FLOW TEST MODULE - BS4
  • Accessory of BS
Available
6.1.2.1.- SENSORS AND ELECTRONIC INSTRUMENTATION
BS4
Flow Test Module
Accessory of BS
Flow Test Module, "BS4", has been designed by EDIBON show techniques to measure changeable fluids.The module is made up of two tanks assembled on a structure. In one of them there is a pumping system that allows to pump the water from the reserve...
View Unit
FLOW TEST MODULE FOR PLC - BS4-PLC
Available
6.2.3.- INSTRUMENTATION AND CONTROL WITH PLC
BS4-PLC
Flow Test Module for PLC
Accessory of BS-PLC
The "BS4-PLC" has been designed to study the flow measurement techniques and control with PLC. This unit is unit with two tanks assembled on a structure with a pumping system that allows pumping the water from the reservoir tank, through the...
View Unit
FLOW VISUALIZATION IN CHANNELS - FME09
  • FME09
Available
8.1.5.- FLOW VISUALIZATION
FME09
Flow Visualization in Channels
The Flow Visualization in Channels unit, "FME09", designed by EDIBON, allows the visualization of liquid spillage phenomena in weirs and the study of objects submerged in a fluid stream (aerodynamics).The unit consists of a transparent...
View Unit
FLOWMETER CALIBRATOR - FME37
  • FME37
Available
8.1.2.- MEASUREMENT
FME37
Flowmeter Calibrator
The Flowmeter Calibrator unit, "FME37", designed by EDIBON, allows for the assessment of the accuracy and performance of the most commonly used flow meters. It features a panel of four-tube pressure gauges displaying pressure differences at...
View Unit
FLUID FRICTION IN PIPES UNIT - AFT/P
  • AFT/P
Available
8.8.- FLUID PIPING SYSTEM
AFT/P
Fluid Friction in Pipes Unit
The Fluid Friction in Pipes Unit, "AFT/P", is designed to determine the friction coefficient in pipes, to study the pressure losses in different types of valves and different fittings and to compare different methods to measure the flow.This unit...
View Unit
FLUID FRICTION IN PIPES UNIT, WITH HYDRAULICS BENCH (FME00) - AFT
  • AFT
Available
8.8.- FLUID PIPING SYSTEM
AFT
Fluid Friction in Pipes Unit, with Hydraulics Bench (FME00)
The unit Fluid Friction in Pipes Unit, with Hydraulics Bench (FME00), "AFT", contains six straight pipe sections made of different materials and with different diameters and roughness. Additionally, a wide range of accessories are included for the...
View Unit
FLUID PROPERTIES - FME35
  • FME35
Available
8.1.3.- HYDROSTATICS
FME35
Fluid Properties
The Fluid Properties unit, "FME35", designed by EDIBON, allows the study of the fluids fundamental properties that affect their behavior in practical applications.We can study capillarity, density and relative density (specific gravity), buoyancy...
View Unit
FLUID STATICS AND MANOMETRY - FME34
  • FME34
Available
8.1.2.- MEASUREMENT
FME34
Fluid Statics and Manometry
The Fluid Statics and Manometry unit, "FME34", designed by EDIBON, allows the study of static fluids and manometry providing the user with an introduction in the behavior of liquids under hydrostatic conditions (fluids at standstill) and the...
View Unit
Ask for information