The Absorption Refrigeration Unit, "TRAB", developed by EDIBON, is a complete laboratory unit for the demonstration of absorption refrigeration.This unit is provided with a dual power source (heat source) of LPG and electricity. A pressure...

The Acceleration of Geared Systems Unit "MAE" allows to perform tests to calculate the moment of inertia of a gear train system.The MAE unit includes six gears. Two of them can have another position in the shafts to vary the gear ratio, allowing...

The Ackermann Steering Mechanism, "MDA", is a bench-mounted unit designed to determine the lead angle of a steering trapezoid in an Ackermann steering mechanism, the disadvantages of incorrectly adjusted track rods and the influence of the track...

The Advanced Computer Controlled Continuous Distillation Unit "UDCC/A" is an installation that allows the study of fractional distillation using a packed column which is able to operate with different packings.There is a feeding system that...

The Advanced Crystallization Unit, "QUCB/A", designed by EDIBON, is a crystallization unit based on the cooling method that allows for observing and studying the mass transfer industrial operation in which a solid is formed from a homogeneous...

The Advanced Dissectable and Configurable Electrical Machines (AEL-EMT-KIT) is a set of configurable electrical machines designed to study the basic principles of electrical machines: Dissectible mechanical pieces. Assembled and disassembled...

Industrial customers use three-phase power consumption with different power factors. If their power factor drops below a prescribed value, power losses in transmission lines increase. For this reason, the customers have to pay a penalty. In order...

The Aerodynamic Tunnel, 300 x 300 mm, "TA300/300", is a wind tunnel designed to study subsonic aerodynamics in a tunnel in open circuit and with incompressible subsonic flow. Air is drawn by a variable speed fan located at the discharge end of the...

The Aerodynamic Tunnel, 50 x 250 mm, "TA50/250", is a wind tunnel designed to study subsonic aerodynamics in a tunnel in open circuit and with incompressible subsonic flow. Air is drawn by a variable speed fan located at the discharge end of the...

The "RYC-TAR" Air Flow Temperature Control module has been designed to study a practical control system, through the control of an air flow temperature.The "RYC-TAR" module consists of two main components: the "RYC-TAR" apparatus and the "RYC-TAR"...

The Air Humidity Measurement Unit, "TMHA", enables the differences in accuracy between different instruments to measure the air relative humidity. It also includes a fan to show the effects of airflow on the different instruments. A mobile...

The ALLEN BRADLEY PLC Application, "AE-PLC-AB", is a PLC unit designed by EDIBON which use one of the last ALLEN BRADLEY PLC units. It allows the user to learn about PLC logic programming, different PLC programming languages, PLC to PC...

In contrast to DC, which always has the same direction and sense, in AC the flow of electrons changes direction periodically with a frequency of 50 or 60 Hz (depending on the country).With Alternating Current (AC) Circuits Module, "N-M2", designed...

The Alternator Study Application, "AEL-EEA", has been designed by EDIBON to study the behavior of three-phase synchronous generators with independent excitation.This application consists of a motor-generator group and a series of modules that...

Measurement of the volumetric concentrations according to the procedure of nondispersiva infrared absorption.Engines selection: gasoline, butane, propane, 2/4 times, 1/2/3/4/5/6/8/12 cylinders.Fast warm-up of the measure cell.Auto-check...

Most of the "information" generated in the world by various physical phenomena has a strong analogical character. This means that the information undergoes a continuous variation within certain limits determined over time. Of course, there is also...

The Analysis of Three-phase Power Lines Application, "AEL-TI-01", includes a series of modules which allow the study of the most important characteristics of aerial lines, among them we can find: the aerial line module, which is configurable with...

This AC Three-Phase Induction Motors Application, "AEL-ACEM", consists of a base equipment which is formed by several modules such as power supplies, push buttons, three-phase autotransformer, A.C. ammeter, circuit breakers, timers, flywheel, etc....

The Wind Power Application with Permanent Magnets Synchronous Generator, with SCADA, "AEL-WPTC", has been designed to study the conversion of wind energy into electricity by means of a permanent magnet synchronous generator. This application...

The Photovoltaic Power Plants Application, with SCADA, ''AEL-PHVGC'', has been designed to study the operations carried out in photovoltaic power systems connected to the energy national grid. This application allows to study the procedure of...

This unit allows different practices related to the measurement of light intensity to be carried out. Photodiodes are semiconductor light sensors that generate a current or voltage when the P-N junction in the semiconductor is illuminated with...

The Application of AC Three-Phase Induction Motor of Squirrel Cage, "AEL-ACINA", is designed for the study of the main operationsperformed in the industrial field with three-phase squirrel cage induction motors. The student will learn the most...

The Applications for Process Control, "APC", designed by EDIBON, allows the student to design, assemble and configure various control systems, apart from studying the fundamentals of the control engineering on which they are based.These...

The Assembly and Maintenance in Refrigeration Systems Unit, "TAMR", has been designed to teach the students the planning, implementation and checking of processes related to the assembly, startup and maintenance of refrigeration systems.The fully...

The centrifugal pumps belong to the group of rotodynamic pumps, where the fluid is boosted thanks to the acceleration acquired whenpassing through the operating impeller. This acceleration, which starts from the center of the impeller and goes to...

The Audio and Video Door Station Application, "AEL-AD14", has been designed by EDIBON to show the functionality of an audio and video door entry system.The video entry phone is a stand-alone intercom application system used to manage calls made at...

The "N-EM" are a series of emulators that provide the students the required hardware to emulate the most common automatic systems.The "N-EM" modules are designed to work with the "AE-PLC" units to obtain the fundamental knowledge of PLC...