Best sales

Best sellers

Showing 433-468 of 938 item(s)

DIRECT CURRENT (DC) CIRCUITS KIT - M1/KIT

Accessory of M-KITS

Available

2.2.- KITS FOR CIRCUITS ASSEMBLY

M1/KIT

Direct Current (DC) Circuits Kit

Accessory of M-KITS

With the Direct Current (DC) Circuits Kit, "M1/KIT", designed by EDIBON, you can begin to study the basic principles of direct current.

DIRECT CURRENT (DC) CIRCUITS MODULE - N-M1

N-M1

Available

14.2.1.1.- BASIC ELECTRICAL LAWS CONCEPTS

N-M1

Direct Current (DC) Circuits Module

For the correct understanding of electronics it is necessary to know some fundamental laws and theorems such as Ohm’s Law, Kirchhoff’s Laws and other simple theorems of initiation to D.C. circuits.With Direct Current (D.C.) Circuits Module,...

Available

7.2.1.- BRAKES AND CLUTCHES

MFD

Disc Brake Unit

The Disc Brake Unit, "MFD", has been designed by EDIBON to carry out experiments to investigate the relationship between the normal force acting on the brake pads, the effective radius of the brake pads and the braking torque.The brake pads are...

DISSECTIBLE MOTORS-GENERATORS APPLICATION - AEL-DMG-KIT

AEL-DMG-KIT

Available

4.4.2.- DETACHABLE MODELS

AEL-DMG-KIT

Dissectible Motors-Generators Application

The Dissectible Motors-Generators Application, "AEL-DMG-KIT", has been designed by EDIBON for the training at theoretical-practical level about the assembly of the following electric motors: DC Compound with Shunt-Series Motor-Generator,...

DISTRIBUTION TRANSFORMER WITH MOTOR REGULATION APPLICATION - AEL-TI-02

AEL-TI-02

Available

5.1.3.2.- POWER TRANSMISSION

AEL-TI-02

Distribution Transformer with Motor Regulation Application

The Distribution Transfomer with Motor Regulation Application, "AEL-TI-02", has been designed to study the distribution transformers and its importance in voltage regulation of the medium and low voltage stage of the electrical system. For that,...

DOUBLE EFFECT RISING FILM EVAPORATOR - EDPAB

EDPAB

Available

11.1.2.- EVAPORATION

EDPAB

Double Effect Rising Film Evaporator

The Double Effect Rising Film Evaporator, "EDPAB", designed by EDIBON, allows to observe and control a serial, parallel or double effect evaporation process.The unit consists of two evaporators with a single glass tube, allowing the student to...

Available

13.1.- HYDROLOGY AND HYDROGEOLOGY

PPD

Drain Permeameter

The Drain Permeameter, "PPD", has been designed to measure the permeability of different filter materials when a fluid is passing through them, as well as to determine the most optimal combination of filter/soil.The main element is a transparent...

PDFD

Available

11.1.11.- FILTRATION, SEDIMENTATION AND MIXING

PDFD

Drainage and Seepage Tank

The Drainage and Seepage Tank, "PDFD", unit has been designed for the practical demonstration, visualization and experimental study of the flow through permeable media and flows in subsoil.The "PDFD" unit basically consist of a tank (soils...

AE-PLC-ST

Available

6.2.5.2.- PROCESSING WORKSTATIONS APPLICATIONS

AE-PLC-ST

Drilling Workstation

The "AE-PLC-ST" is an automatic drilling workstation commanded by a PLC. The "AE-PLC-ST" also include a conveyor system to transport the incoming pieces to the drilling zone where the drilling machine simulate the process.The "AE-PLC-ST"...

TIAP

Available

9.10.3.- INSTALLATIONS AND MAINTENANCE TRAINING

TIAP

Drinking Water Installation Unit

The Drinking Water Installation Unit, "TIAP", has been designed to demonstrate domestic water heating from the cold water supply. A typical domestic drinking water system is attached to the front panel of the unit. The unit includes the most...

DRIVE UNIT FOR TRIBOLOGICAL TESTS - MEMT-UB

Accessory of MEMT

Available

7.1.5.- TRIBOLOGY (FRICTION, WEAR, LUBRICATION)

MEMT-UB

Drive Unit for Tribological Tests

Accessory of MEMT

This unit is common for the modules type "MEMT".It consists of a base unit and an electronic console:The Base Unit consists of a drive unit formed by a DC motor with a shaft. The motor is mounted in a reduction gear, obtaining enough torque in the...

DRIVE, SHAFT, AND GEAR ALIGNMENT UNIT - ADSG

ADSG

Available

7.4.3.- INSTALLATIONS AND MAINTENANCE TRAINING

ADSG

Drive, Shaft, and Gear Alignment Unit

The Drive, Shaft, and Gear Alignment Unit, "ADSG", allows for studying the coupling and uncoupling, maintenance, repair of the related units and checking the operation with the following units:CGA. Combined Gear Assembly Unit.SGA. Spur Gear...

DROP BALL VISCOMETER AND RESISTANCE COEFFICIENT DETERMINATION UNIT - HVB

Available

8.2.- MEASUREMENT

HVB

Drop Ball Viscometer and Resistance Coefficient Determination Unit

The Drop Ball Viscometer and Resistance Coefficient Determination Unit, "HVB", designed by EDIBON, consists of two precision transparent tubes fixed onto a frame in which a ball is allowed to drop down through different liquids. Both tubes can be...

Available

7.2.1.- BRAKES AND CLUTCHES

MFT

Drum Brake Unit

The Drum Brake Unit, "MFT", designed by EDIBON, allows the study of the forces acting on a drum brake, the difference between the braking torque of the primary shoe and secondary shoe braking systems and determining the coefficient of friction...

DUTCH VAT FOR CHEESE PRODUCTION (UNTIL 50L) - DVCP

DVCP

Available

12.2.- DAIRY PRODUCTS TREATMENT

DVCP

Dutch Vat for Cheese Production (until 50l)

The Dutch Vat for Cheese Production (until 50l), "DVCP", designed by EDIBON, has a tank with water jacket, coil with inlet and outlet for water from the boiler, jacket water inlet, serum drainage valve and set of accessories for the agitation,...

DYNAMIC FRICTION OF A CYLINDER ON A ROLLER - MEMT-2

Accessory of MEMT

Available

7.1.5.- TRIBOLOGY (FRICTION, WEAR, LUBRICATION)

MEMT-2

Dynamic Friction of a Cylinder on a Roller

Accessory of MEMT

This unit allows to demonstrate the friction forces between several cylinders of different materials and a roller under different lubrication conditions.The "MEMT-2" unit consists of two levers that transmit a force applied by weights to a test...

DYNAMIC FRICTION OF A PIN ON A DISC - MEMT-3

Accessory of MEMT

Available

7.1.5.- TRIBOLOGY (FRICTION, WEAR, LUBRICATION)

MEMT-3

Dynamic Friction of a Pin on a Disc

Accessory of MEMT

This unit allows to study the friction forces between several vertical friction pins of different materials and a rotating friction disc.The end of each vertical pin is made of a different material and rubs against the rotating steel disc. The...

Accessory of LIMEBA

Available

7.1.1.- MECHANICS FUNDAMENTALS KITS

MECA4

Dynamics Experiments

Accessory of LIMEBA

Dynamics is the part of Mechanics that analyzes the motion of an element or mechanism caused by a force. Thus the study is concentrated on the basic laws of Dynamics.

Accessory of MEMT

Available

7.1.5.- TRIBOLOGY (FRICTION, WEAR, LUBRICATION)

MEMT-5

Elastohydrodynamic Lubrication

Accessory of MEMT

This unit allows to investigate the thickness and characteristics of a lubricant film on a rolling sphere.The unit consists in a steel sphere and a driven glass disc.The sphere is pressed against the underside of the glass disc. The light from a...

Accessory of EFAC

Available

1.1.- 3D PHYSICS

FCE

Electric Fields Study Set

Accessory of EFAC

The Electric Fields Study Set, "FCE", allows the spatial study of the electric field in all its dimensions: calculation of the intensity, force lines, equipotential surfaces in both static and dynamic fields, giving the student a more extensive...

Accessory of M-KITS

Available

2.2.- KITS FOR CIRCUITS ASSEMBLY

M16/KIT

Electric Networks Kit

Accessory of M-KITS

With the Electric Networks Kit, "M16/KIT", designed by EDIBON, it is possible to understand the principles of Ohm’s Law, Norton’s and Thévenin’s Theorem, Wheatstone bridge operation, superposition theorems or star/delta transformation and viceversa.

N-M16

Available

14.2.1.1.- BASIC ELECTRICAL LAWS CONCEPTS

N-M16

Electric Networks Module

After studying the basic knowledge of electrical networks, we must understand and investigate the dependence between current and voltage applied to different electrical devices.With the Electric Networks Module, "N-M16", designed by EDIBON, it is...

ELECTRICAL FAULTS IN AIR CONDITIONING SYSTEMS UNIT - TEFA

TEFA

Available

9.10.3.- INSTALLATIONS AND MAINTENANCE TRAINING

TEFA

Electrical Faults in Air Conditioning Systems Unit

The Electrical Faults in Air Conditioning Systems Unit,"TEFA", is designed in a simple way in order to transmit comprehensible knowledge about how identify electrical faults in air conditioning systems. For this purpose, concepts are included to...

ELECTRICAL INSTALLATIONS IN REFRIGERATION SYSTEMS UNIT - TEIR

TEIR

Available

9.10.3.- INSTALLATIONS AND MAINTENANCE TRAINING

TEIR

Electrical Installations in Refrigeration Systems Unit

For this purpose this unit has been designed to teach the students about different circuits and electrical devices associated with the refrigeration field, how to carry out the wirings of these types of installations, how the refrigeration...

ELECTRICAL MACHINES CONTROL THROUGH FREQUENCY CONTROLLER APPLICATION - AEL-EMCF

AEL-EMCF

Available

4.3.2.1.- AC ELECTRICAL MOTORS AND GENERATORS

AEL-EMCF

Electrical Machines Control through Frequency Controller Application

The Electrical Machines Control through Frequency Controller Application, "AEL-EMCF", has been designed by EDIBON to instruct the student in managing of frequency controllers for the control of three phase induction electrical machines.This...

ELECTRICAL MACHINES SOFT STARTERS APPLICATION - AEL-EMSS

AEL-EMSS

Available

4.3.2.1.- AC ELECTRICAL MOTORS AND GENERATORS

AEL-EMSS

Electrical Machines Soft Starters Application

The Electrical Machines Soft Starters Application, "AEL-EMSS", has been designed by EDIBON to instruct the student in managing soft-starters of three-phase electrical machines. This application basically consists of three types of optional...

EDILAB-ELEC1

Available

5.3.9.- HYDROGEN FUEL CELLS

EDILAB-ELEC1

Electrolyzer (3 Nl/h)

The Electrolyzer (3 Nl/h), "EDILAB-ELEC1", consists of an electrolyzer to generate hydrogen which uses a high performance and efficiency system based on water electrolysis. Hydrogen to be used safely is obtained from it. The electrolysis cell is a...

EDILAB-ELEC2

Available

5.3.9.- HYDROGEN FUEL CELLS

EDILAB-ELEC2

Electrolyzer (60 Nl/h)

The Electrolyzer (60 Nl/h), "EDILAB-ELEC2", designed by EDIBON, can separate hydrogen and oxygen from water by applying electricity.The "EDILAB-ELEC2", consists of an electrolyzer to generate hydrogen which uses a high performance and efficiency...

N-M17

Available

14.2.1.1.- BASIC ELECTRICAL LAWS CONCEPTS

N-M17

Electromagnetism Module

Electromagnetism is the interaction between electric charges. It is described in terms of charges interacting between of electric and magnetic fields.With the Electromagnetism Module, "N-M17", designed by EDIBON, the operation of electromagnetic...

FOR FURTHER INFORMATION, CONTACT US