On October 19th, the Course on Instrumentation, Regulation and Control in Laboratories, taught by our engineers in these facilities, using EDIBON units, was completed and aimed at learning the control of the conditions of a laboratory process.
The attendants, (12 laboratory technicians and...
1011 PROCESS CONTROL.Medium Module
HIGHER TECHNICAL EDUCATION
FOOD ENGINEERING
TEXTILE ENGINEERING
CHEMISTRY
CHEMICAL ENGINEERING
PROCESS ENGINEERING
PETROLEUM TRAINING CENTER
ENERGY TRAINING CENTER
INTERNATIONAL CENTER FOR TECHNICAL TRAINING, DEVELOPMENT AND RESEARCH
RELATED NEWS
Exercises and guided practices
GUIDED PRACTICAL EXERCISES INCLUDED IN THE MANUAL
- Characterization of the water hammer phenomenon in pipes.
- Subduing the water hammer effects.
- Calculation of energy losses in pipes.
- Influences of the pipe diameter on the speed propagation.
- Subduing of the effects of the water hammer through abrupt expansions.
MORE PRACTICAL EXERCISES TO BE DONE WITH THE UNIT
- Sensors calibration.
SUPPLEMENTARY EQUIPMENT
6.1.1.3.- INDUSTRIAL SYSTEM APPLICATIONS
UCP-P
The Computer Controlled Process Control Unit for the Study of Pressure (Air), "UCP-P", consists of a compressed air duct whose flow is controlled by a pneumatic valve (the compressed air or gas source is not included). The air is supplied through...
6.1.1.3.- INDUSTRIAL SYSTEM APPLICATIONS
UCPCN
Computer Controlled Process Control (Pneumatic Valve)
The Computer Controlled Process Control (Pneumatic Valve), "UCPCN", designed by EDIBON, allows the study of several types of automatic control and can be used to control different variables (flow, level, temperature, pressure, pH, conductivity and...
6.1.1.3.- INDUSTRIAL SYSTEM APPLICATIONS
UCPCV
Computer Controlled Process Control (Speed Controller)
The Computer Controlled Process Control Unit (Speed Controller), "UCPCV", designed by EDIBON, allows the study of several types of automatic control and can be used to control different variables (flow, level, temperature, pressure, pH,...