Лидеры продаж

Показано 421-432 из 931

COMPUTER CONTROLLED UNIT TO STUDY THE EFFICIENCY OF A HEATING SYSTEM - TEHSC

TEHSC

Available

9.2.- ОТОПЛЕНИЕ, ВЕНТИЛЯЦИЯ, КОНДИЦИОНИРОВАНИЕ ВОЗДУХА И ГОРЯЧАЯ ВОДА

TEHSC

Оборудование для изучения эффективности системы отопления, управляемое компьютером (ПК)

The Computer Controlled Unit to Study the Efficiency of a Heating System, "TEHSC",designed by EDIBON allows for studying and analyzing a closed heating system made upof pipes with different diameter and fittings normally used in real heating...

EMDA/P

Available

3.2.1.- КОДИРОВАНИЕ, МОДУЛЯЦИЯ И ТЕОРИЯ ОБРАБОТКИ СИГНАЛА

EMDA/P

Оборудование для импульсной модуляции

The Pulse Modulations Unit, "EMDA/P," has been designed by EDIBON to explain the fundamental concepts of pulse modulation in its entirety. It encompasses the principles of many modulation and demodulation techniques used in modern communication...

Available

11.1.9.- ИОНООБМЕН И КОРРОЗИЯ

EII

Оборудование для ионного обмена

The Ion Exchange Unit, "EII", is a self-contained unit composed by a panel, where two transparent columns are situated in order to put anionic and cationic resins, and also a spare column and a pump, which supplies the efficient from the tanks...

COMPUTER CONTROLLED ION EXCHANGE UNIT - EIIC

EIIC

Available

11.1.9.- ИОНООБМЕН И КОРРОЗИЯ

EIIC

Оборудование для ионного обмена, управляемое компьютером (ПК)

The Computer Controlled Ion Exchange Unit, "EIIC", is a self-contained unit consisting of a panel with two transparent columns to be filled with anionic and cationic resins, plus a spare column and a computer controlled pump that supplies the...

COMPUTER CONTROLLED TWO-STAGE COMPRESSOR TEST UNIT - HCDEC

HCDEC

Available

8.7.5.- КОМПРЕССОРЫ

HCDEC

Оборудование для испытаний двухступенчатого компрессора, управляемое компьютером (ПК)

The Computer Controlled Two-Stage Compressor Test Unit, "HCDEC", works with compressed air and presents as a principal device a compression bench with two pistons, low and high pressure.This unit presents four circuits or work dispositions which...

CHARPY AND IZOD IMPACT TESTING UNIT - EEICI

EEICI

Available

7.3.2.1.- МЕХАНИЧЕСКИЙ ТЕСТ

EEICI

Оборудование для Испытаний на Ударную Вязкость по Шарпи и Изоду

The Charpy and Izod Impact Testing Unit, "EEICI", consists of a pendulum supported on bearings with an arm of 330 mm long and a fastening system in the initial position of the test. The suitable hammer either for Charpy or Izod test is screwed to...

Available

7.3.2.1.- МЕХАНИЧЕСКИЙ ТЕСТ

MTT

Оборудование для испытания на кручение (30 Нм)

To perform the tests, the test specimen is clamped and twisted by means of a flywheel and a worm gear until it breaks. The force is gradually applied to the specimen to observe the elastic strain produced. The specimen will deform and manifest...

MTTU

Available

7.3.2.1.- МЕХАНИЧЕСКИЙ ТЕСТ

MTTU

Оборудование для испытания на растяжение

With the Tensile Tester Unit, "MTTU", designed by EDIBON, tensile test can be performed. A specimen made of different materials is subjected to an increasing axial tensile stress till failure. This unit allows the user to perform tensile tests...

EEICI/300

Available

7.3.2.1.- МЕХАНИЧЕСКИЙ ТЕСТ

EEICI/300

Оборудование для Испытания на Удар по Методам Шарпи и Изода, 300Нм

The 300 Nm Charpy and Izod Impact Testing Unit, "EEICI/300", designed by EDIBON, consists of a pendulum supported by bearings with a 900 mm long arm and a clamping system at the starting position of the test. At one end of the pendulum, either the...

Available

7.3.2.1.- МЕХАНИЧЕСКИЙ ТЕСТ

EEF

Оборудование для испытания на усталость

The Fatigue Testing Unit, "EEF", designed by EDIBON, allows to study the fatigue strength of the materials. For that purpose, fatigue tests are performed with different materials and notches.Optionally, with the additional recommended element Set...

COMPUTER CONTROLLED FATIGUE TESTING UNIT - EEFC

EEFC

Available

7.3.2.1.- МЕХАНИЧЕСКИЙ ТЕСТ

EEFC

Оборудование для испытания на усталость, управляемое компьютером (ПК)

The Computer Controlled Fatigue Testing Unit, "EEFC", designed by EDIBON, allows to study the fatigue strength of the materials. For that purpose, fatigue tests are performed with different materials and notches.Optionally, with the additional...

EEFCR

Available

7.3.2.1.- МЕХАНИЧЕСКИЙ ТЕСТ

EEFCR

Оборудование для испытания ползучести

The Creep Testing Unit, "EEFCR", for the creep testing is mounted on a structure of aluminum profiles which a painted steel panel is supported on.The "EEFCR" unit is designed to carry out experiments on specimens of plastic materials. Due to the...

ЧТОБЫ ПОЛУЧИТЬ БОЛЬШЕ ИНФОРМАЦИИ, СВЯЖИТЕСЬ С НАМИ