On October 19th, the Course on Instrumentation, Regulation and Control in Laboratories, taught by our engineers in these facilities, using EDIBON units, was completed and aimed at learning the control of the conditions of a laboratory process.
The attendants, (12 laboratory technicians and...
1011 PROCESS CONTROL.Medium Module
EDUCAÇÃO TÉCNICA SUPERIOR
ENGENHARIA DE ALIMENTOS
ENGENHARIA TÊXTIL
QUÍMICA
ENGENHEIRO QUÍMICA
ENGENHARIA DE PROCESSOS
CENTRO DE FORMAÇÃO DE PETRÓLEO
CENTRO DE FORMAÇÃO DE ENERGIA
CENTRO INTERNACIONAL DE FORMAÇÃO TÉCNICA, DESENVOLVIMENTO E INVESTIGAÇÃO
SISTEMAS INOVADORES
The Computer Controlled Water Hammer Unit, “EGAC”, is designed to demonstrate the effects of an instantaneous variation of the speed of a fluid.
Expansões
NOTÍCIAS RELACIONADAS
Descrição Geral
The Computer Controlled Water Hammer Unit, “EGAC”, is designed to demonstrate the effects of an instantaneous variation of the speed of a fluid. It is possible to study the water hammer, which is the consequence of a quick change in a fluid speed.
Besides, damping of water hammer effects by using surge tanks can also be demonstrated.
The unit includes a hydraulic system with a centrifugal pump, which transfers water from the tank of the hydraulic system to the a constant level tank. This last tank supplies three different circuits to carry out the practical exercises. It can keep a constant pressure level at the three outlets by means of an inner wall. Besides, there is a valve that makes it possible to control the reflux from the hydraulic system to the constant level tank. A variable area flow meter is included to measure the reflux.
There are four testing circuits made of several materials and with different diameters to study their influence and to compare the results from every circuit. Each circuit has a quick-closing impact valve that generates the characteristic over-pressure of the water hammer. They also guarantee a quick closing without vibrations that could affect the measurements.
It also includes a discharge tank used to calm the water. Moreover, it provides the means of checking visually that the circuit under study is working.
Finally, there are three surge tanks which can be adapted to nine points of the system. They make it possible to study the conversion of the kinetic energy, released during the abrupt stopping of the water mass, into potential energy. Furthermore, the generated pressure vibrations can be analyzed by placing both pressure sensors at any of the twelve points of the circuits.
EXERCÍCIOS E PRÁTICAS GUIADAS
EXERCÍCIOS PRÁTICOS GUIADOS INCLUÍDOS NO MANUAL
- Characterization of the water hammer phenomenon in pipes.
- Subduing the water hammer effects.
- Calculation of energy losses in pipes.
- Influences of the pipe diameter on the speed propagation.
- Subduing of the effects of the water hammer through abrupt expansions.
EXERCÍCIOS MAIS PRÁTICOS A SEREM FEITOS COM A UNIDADE
- Sensors calibration.
EQUIPAMENTOS COMPLEMENTARES
6.1.1.3.- APLICAÇÕES DE SISTEMAS INDUSTRIAIS
UCP-P
The Computer Controlled Process Control Unit for the Study of Pressure (Air), "UCP-P", consists of a compressed air duct whose flow is controlled by a pneumatic valve (the compressed air or gas source is not included). The air is supplied through...
6.1.1.3.- APLICAÇÕES DE SISTEMAS INDUSTRIAIS
UCPCN
Controle de Processos (Válvula Pneumática), Controlado por Computador (PC)
The Computer Controlled Process Control (Pneumatic Valve), "UCPCN", designed by EDIBON, allows the study of several types of automatic control and can be used to control different variables (flow, level, temperature, pressure, pH, conductivity and...
6.1.1.3.- APLICAÇÕES DE SISTEMAS INDUSTRIAIS
UCPCV
Controle de Processos (Variador de Velocidade), Controlado por Computador (PC)
The Computer Controlled Process Control Unit (Speed Controller), "UCPCV", designed by EDIBON, allows the study of several types of automatic control and can be used to control different variables (flow, level, temperature, pressure, pH,...