관련 뉴스

일반적인 설명

Unit for the demonstration of the methods of noise and vibration control. It allows audible experimentation of the effect of the noise frequency on the effectiveness of attenuation methods.

연습 및 가이드

매뉴얼에 포함 된 가이드 실기 연습

  1. Demonstration of noise and vibration control.
  2. Study of the transmission of noise along ducts and the methods of attenuation using acoustic linings.
  3. Study of the transmission of noise along solid paths and the methods of reduction by isolation.
  4. Demonstration of the attenuation of mechanical or aerodynamic noise source using a rigid enclosure and combining this with an absorbent acoustic lining.
  5. Demonstration of the rapid degeneration in effectiveness of the enclosure method, due to minor imperfections in construction.
  6. Study of the rigid body modes of vibration of a resiliently mounted source.
  7. Study of the effects of mass variation of the resonant frequencies and modes of vibration.
  8. Study of the effect of the noise frequency on the effectiveness of attenuation methods.
  9. Sensors Calibration

장비로 수행 할 수있는 더 많은 실용적 연습

  1. Many students view results simultaneously. To view all results in real time in the classroom by means of a projector or an electronic whiteboard.
  2. Open Control, Multicontrol and Real Time Control.
  3. This unit allows intrinsically and/or extrinsically to change thespan, gains, proportional, integral, derivative parameters, etc, in real time.
  4. The Computer Control System with SCADA allows a real industrial simulation.
  5. This unit is totally safe as uses mechanical, electrical and electronic, and software safety devices.
  6. This unit can be used for doing applied research.
  7. This unit can be used for giving training courses to Industries even to other Technical Education Institutions.
  8. Control of the TDRC unit process through the control interface box without the computer.
  9. Visualization of all the sensors values used in the TDRC unit process.

품질

판매 후 서비스