5.7.- INSTALLATIONS AND MAINTENANCE

The needs of today's society are a challenge for any industry, since they have to be in continuous evolution and renewal to adapt to those needs.

View more

In recent years, as a result of the new industrial revolution or "Industry 4.0", the emergence of the "Industrial Internet of Things" ("IIoT") and the "Smart Factories", that adaptation is possible thanks to the application of the most sophisticated techniques in the design of new facilities or in the renovation of existing ones.

In spite of all these technological advances and the exhaustive controls carried out, it should not be forgotten that any element that take part in the productive process is going to be subjected to a mechanical and electrical wear (efforts, loads, etc.) and its useful life is limited. To avoid catastrophic failures, stoppages in production or any type of process that implies an increase of non-productive times and, therefore, an increase of costs, it is extremely important to carry out a good maintenance of machinery, electrical systems, etc.

Traditionally, only two types of maintenance were considered:

  • Corrective: the fault is solved once it has already occurred.
  • Preventive: periodic review of all those problematic elements and their replacement if required.

These types of maintenance involve very high and unnecessary costs in most cases. Nowadays, thanks to the available technology, it is possible to carry out predictive maintenance consisting of a comprehensive analysis of all those variables that take part in all the components of a system and be able to replace them at the right time.

But, if more control over the failures that can suffer all those mechanical components subject to wear is preferred, there is another type of maintenance, known as proactive maintenance. It goes one step further than the predictive maintenance, looking for the root of the problem.

View Products
INSTALLATIONS AND MAINTENANCE UNITS
Showing 1-4 of 4 item(s)
MEASUREMENT AND REGULATION STATION UNIT - MRST
  • MRST
Available
9.10.3.- INSTALLATIONS AND MAINTENANCE TRAINING
MRST
Measurement and Regulation Station Unit
The Measurement and Regulation Station Trainer,"MRST", designed by EDIBON is a totally accessible bench-top unit. The unit works with an air compressor that simulates the gas flowing inside the pipes (air testing), allowing to check the tightness...
INSTANTANEOUS GAS HEATER EXPERIMENTATION UNIT - IGHT
  • IGHT
Available
9.10.3.- INSTALLATIONS AND MAINTENANCE TRAINING
IGHT
Instantaneous Gas Heater Experimentation Unit
The Instantaneous Gas Heater Trainer, ,IGHT,, designed by EDIBON, is a training unit with wheels to facilitate its mobility that represents a gas heater training system. The unit operates with air, simulating the operation of the heater, so it can...
FORCED DRAFT GAS BURNER UNIT - GBT
  • GBT
Available
9.10.3.- INSTALLATIONS AND MAINTENANCE TRAINING
GBT
Forced Draft Gas Burner Unit
The Forced Air Gas Burner Trainer, "GBT", designed by EDIBON, is a compact teaching unit with wheels to facilitate its mobility. It represents a controlled gas system that supplies a forced air gas burner. It allows the study of the arrangement,...
GAS HOME SUPPLY TRAINER - GHST
  • GHST
Available
9.10.3.- INSTALLATIONS AND MAINTENANCE TRAINING
GHST
Gas Home Supply Trainer
The Gas Home Supply Trainer, ,GHST,, designed by EDIBON, consists of a teaching unit where the elements normally used on any domestic gas installation are arranged on the front panel of the unit as in a real installation. The unit works with air,...
Ask for information